Installation Methods For Check Valves

Oct 13, 2026

Leave a message

Swing Check Valve: The disc of a swing check valve is circular and rotates around an axis located outside the valve seat passage. Because the internal flow passage is streamlined, it offers lower flow resistance compared to lift check valves. It is suitable for large-diameter applications with low flow velocities and infrequent flow changes; however, it is not recommended for pulsating flow, and its sealing performance is generally inferior to that of lift check valves. Swing check valves are categorized into single-disc, dual-disc, and multi-disc types-a classification primarily based on the valve diameter-designed to mitigate hydraulic shock when the medium stops flowing or reverses direction.
Lift Check Valve: In this type, the disc slides along the vertical centerline of the valve body. Lift check valves must be installed on horizontal pipelines; for high-pressure, small-diameter applications, the disc may take the form of a sphere (ball). The valve body design is identical to that of a globe valve (and can even be interchangeable with one), which results in a relatively high flow resistance coefficient. Its internal structure-including the valve body and disc-is similar to that of a globe valve. The upper part of the disc and the lower part of the bonnet are equipped with guide sleeves, allowing the disc to move vertically within the guide. When the medium flows in the intended direction, the pressure pushes the disc open; when the flow stops, the disc descends onto the seat under its own weight, preventing backflow. In a straight-through lift check valve, the inlet and outlet passages are perpendicular to the valve seat passage, whereas in a vertical lift check valve, the inlet and outlet passages are aligned with the valve seat passage, resulting in lower flow resistance.


Disc Check Valve: A type of check valve in which the disc rotates around a pin located within the valve seat. These valves feature a simple design, must be installed on horizontal pipelines, and offer relatively poor sealing performance.
In-line (Pipeline) Check Valve: A valve in which the disc slides along the centerline of the valve body. The in-line check valve is a relatively new type of valve; it is compact, lightweight, and offers good manufacturability, representing one of the key development trends for check valves. However, its fluid resistance coefficient is slightly higher than that of a swing-type check valve.
Compression-type (or globe-style) check valves are designed for use in boiler feedwater and steam shut-off applications, combining the functions of a lift-type check valve with those of a globe valve or angle valve.
Additionally, there are certain types of check valves-such as foot valves, spring-loaded check valves, and Y-pattern check valves-that are not suitable for installation at the discharge side of a pump.

Send Inquiry