Operation Of Globe Valves

Oct 17, 2026

Leave a message

For globe valves, it is essential to know not only how to install and maintain them, but also how to operate them correctly.
When opening or closing a globe valve, apply force steadily and avoid sudden impacts. Note that certain high-pressure globe valves are specifically designed to withstand the forces associated with impact-based operation; these should not be equated with standard globe valves.
Once a globe valve is fully opened, the handwheel should be backed off slightly to tighten the threads, preventing them from loosening or sustaining damage.
When a pipeline is first put into service, it often contains debris. In such cases, the globe valve can be opened slightly, allowing the high-velocity flow of the medium to flush out the impurities. Afterward, close the valve gently-never close it rapidly or forcefully, as residual debris could become trapped and damage the sealing surfaces. Repeat this process several times until the line is clear of debris before commencing normal operation.
For valves that are typically kept open, debris may accumulate on the sealing surfaces. Before closing such valves, use the aforementioned flushing method to clean the surfaces thoroughly, then proceed to close the valve tightly.
If a handwheel or handle is damaged or missing, it must be replaced immediately. Never use an adjustable wrench as a substitute, as this can damage the square end of the valve stem, impairing operation and potentially leading to accidents during production.
With certain media, cooling after the valve is closed can cause the valve components to contract. In such instances, the operator should re-tighten the valve after a suitable interval to ensure no gaps remain on the sealing surfaces. Otherwise, the medium could flow through any remaining gap at high velocity, causing erosion to the sealing surfaces.
If operating the valve proves excessively difficult, investigate the cause. If the packing is too tight, loosen it appropriately; if the valve stem is misaligned, notify maintenance personnel to carry out repairs. In some cases, the closing element of a globe valve may expand due to heat while in the closed position, making it difficult to reopen. If the valve must be opened under these conditions, loosen the bonnet threads by half a turn to one full turn to relieve stress on the valve stem, then attempt to turn the handwheel.

Send Inquiry