(1)Before disassembling a ball valve, ensure that the pressure in the upstream and downstream pipelines has been fully relieved.
(2)Non-metallic components should be removed from the cleaning agent immediately after cleaning; do not leave them submerged for an extended period.
(3)During assembly, the bolts on the flanges must be tightened symmetrically, gradually, and evenly.
(4)The cleaning agent must be compatible with the ball valve's rubber components, plastic components, metal parts, and the working medium (e.g., fuel gas). If the working medium is fuel gas, gasoline (GB484-89) may be used to clean metal parts. Non-metallic components should be cleaned using pure water or alcohol.
(5)Individual components removed during disassembly may be cleaned by immersion. For metal parts that still contain non-metallic components, use a clean, lint-free silk cloth dampened with the cleaning agent (to prevent fibers from shedding and adhering to the parts) to wipe them down. Ensure that all grease, dirt, adhesive residue, and dust are removed from the surfaces.
(6)Exercise caution during disassembly and reassembly to avoid damaging the sealing surfaces of the components-especially non-metallic parts. Use specialized tools when removing O-rings.
(7)After cleaning, allow the cleaning agent to evaporate from the surfaces (or wipe them dry with a clean, dry silk cloth) before proceeding with assembly. Do not leave the parts exposed for too long, as they may rust or become contaminated with dust.
(8)New components must also be cleaned thoroughly before assembly.
(9)Use lubricant grease. The grease must be compatible with the ball valve's metal materials, rubber components, plastic components, and the working medium. If the working medium is fuel gas, a lubricant such as "Te-221" (Special 221) grease may be used. Apply a thin layer of grease to the surfaces of the seal grooves, the rubber seals, and the sealing and friction surfaces of the valve stem. (10) During assembly, ensure that no metal debris, fibers, grease (except where specifically authorized), dust, or other impurities or foreign matter contaminate, adhere to, or remain on the surfaces of parts or within their internal cavities.